RoadEase™ — Secure Your Tablet Perfectly Centered Between Headrests for Comfortable Backseat Viewing
RoadEase™ — Secure Your Tablet Perfectly Centered Between Headrests for Comfortable Backseat Viewing
High Quality
FREE US Shipping
Hassle Free Returns
Couldn't load pickup availability
Mount Your Tablet Snugly Between the Backseats — and End the Bickering Before the Trip Starts
Two kids, one tablet, four hours en route to grandma's place. You know how that story goes. RoadEase™ attaches to both backseat headrests simultaneously and suspends your tablet perfectly centered — so neither child has to lean, twist, or tussle for a glance. Both get a clear view. Both stay peaceful. You actually finish your podcast.
Ditch Wobbly One-Headrest Mounts That Bounce at Every Bump
Most backseat mounts secure to a single headrest and call it a day. One child gets a clear screen. The other leans over, grumbles, kicks the seat. Then a pothole jolts and the whole setup swings sideways. RoadEase™ clamps onto both headrest posts at once — holding the screen center stage, stable, so both kids can watch the same show without fighting.
➤ Positioned Dead-Center Between Both Backseat Headrests: Two arms grip both headrest rods at once, so the tablet floats right down the middle — both kids get a direct view without leaning over each other or squabbling about which side it faces.
➤ Keeps the Screen Rock-Solid Over Every Bump: Dual anchors combined with aluminum arms and silicone-lined pads eliminate the shake that single-arm mounts suffer. No more stopping the movie because the screen swung out of sight on a rough patch.
➤ Fits Phones or 12.9″ iPad Pro — Case Stays On: Spring-loaded jaws hold devices from 4.7″ up to 12.9″, even with a bulky kid case attached. No scratched edges, no slips on bumps, no wrestling the case off before every ride.
What Keeps RoadEase™ Stable While the Car Moves
Typical car tablet mounts hang off one headrest like a flag on a pole. RoadEase™ instead spans both headrests with a horizontal aluminum bar, then suspends the tablet on a 6–27 cm telescoping arm with a 360° ball joint at the device. That extra anchor point is why it stays steady through turns — and why the screen never ends facing the ceiling mid-ride.
Internal geared hinges hold your exact angle — they don’t sag, droop, or drift as the movie plays. Silicone pads grip the headrest rods gently without scratching leather, and the clamp jaws are rubber-lined so even a thin iPad inside a thick kid case locks in without any rattle.
Why Parents on Road Trips Quit Trying Other Mounts
After burning through three $20 single-arm mounts that failed on the first long drive, families stop experimenting. RoadEase™ is the one that endures the potholes, fits iPads with kid cases on, and gives both backseat riders a level view of the screen simultaneously.
"Bought cheap ones twice — they both broke or sagged within a month. This one lasted through two summer trips and my 4-year-old tugging on it daily. Wish I’d grabbed it way earlier." — Megan R.
"Was doubtful it’d fit both headrests in my Highlander. It did, took 30 seconds, and the kids haven’t squabbled over the tablet since." — Daniel K.
Hands-Free Backseat Viewing Without the Neck Strain
✓ Both Kids Watch Straight On Without Neck Twisting: Center positioning means no neck aches, no "shift it to my side" fights, no one craning for four hours.
✓ Stays Firm on Rough Roads and Bumps: Two anchor points plus gear-locked hinges keep the screen steady even when the car isn’t.
✓ Quickly Detaches When Backseat Is Just Backseat Again: 30-second knob release — fold it away or pull it out so the backseat is free.
Set Up in Under a Minute — Zero Tools or Instructions Needed
Step 1: Clamp the two anchor brackets onto your backseat headrest rods. Twist the knobs until secure — no tools, no headrest removal required.
Step 2: Extend the lower arm and tilt it down so the tablet aligns with your kids’ eye level. Lock the joint tight.
Step 3: Snap your phone, iPad, or tablet into the spring-loaded holder. Rotate portrait or landscape using the 360° ball joint and hit play.
| Why RoadEase™ | Single-Arm Headrest Mounts | Kids Holding It Themselves |
|---|---|---|
| Bridges Both Headrests placing the tablet center for both kids | ❌ Mounts to one side — other kid leans | ❌ Holder gets control of screen position |
| Rock-Steady on Rough Roads — dual anchors plus gear hinges | ❌ Wobbles and droops over every bump | ❌ Tablet dropped, screen cracked |
| Fits 4.7″–12.9″ Devices With Cases On — from phone to iPad Pro | ❌ Usually maxes around 10″, no case | ❌ Arms get tired in 15 minutes |
Specifications: What's Under the Hood
- Build: Aluminum-alloy arms, ABS clamp body, silicone-lined headrest pads, rubber-lined device jaws
- Folded Dimensions: 10.8 × 5.0 × 2.2 inches — fits neatly in a glove box
- Lower-Arm Extension: 2.4 to 10.6 inches, adjustable for children of varying heights
- Headrest Rod Spacing Fit: 0.4 to 6.3 inches apart (compatible with most sedans, SUVs, and pickups)
- Device Range: 4.7″ to 12.9″ — phones, mini tablets, full-size tablets, with most kid-friendly cases
- Weight Capacity: Supports up to 10 kg / 22 lbs
Got Questions? We’ve Got Answers
Will this fit my car’s headrests?
It clamps onto headrest rods spaced from 0.4 to 6.3 inches apart, covering the majority of sedans, SUVs, and pickups. If your vehicle has fixed headrests with no exposed rods (like some Volvo models), this mount won’t fit.
Will it hold my iPad Pro 12.9″ with the kid case still attached?
Absolutely. The spring-loaded jaws open up to 12.9″ and grip chunky kid cases firmly without slipping. No need to wrestle the case off before every car ride.
Will it really stay steady on bumpy roads?
That’s the whole idea behind the dual-headrest design. Two anchor points along with internal geared hinges mean it doesn’t sway, sag, or rotate sideways like single-arm mounts do — even over rough highway patches.
Does it block the rearview mirror from the driver’s seat?
The lower arm telescopes from 6 to 27 cm — lower the screen enough to stay out of the rearview mirror’s line of sight. You control the height so you keep a clear view.
Does it require tools or special installation?
Not at all. Just twist the two knobs, clamp it on, and snap the tablet in. Takes less than a minute, no headrest removal, no manual needed.
Give It a Go on Your Next Road Trip — Or Return It with No Fuss
If RoadEase™ doesn’t keep your tablet rock-solid throughout your next journey, or doesn’t fit both your backseat headrests as promised, simply send it back for a full refund. With aluminum arms, gear-locked hinges, and a 10 kg load capacity, it’s made to outlast even the most persistent kid tugs — but if it doesn’t earn a permanent spot in your glove box, you pay nothing.
Rated 4.7 / 5 based on 1289 reviews. Showing our 5-star reviews.